|
ude:~# tail -f /var/log/messages : : Oct 5 07:29:46 ude kernel: usb 2-1: new high speed USB device using ehci_platform and address 2 Oct 5 07:29:46 ude kernel: usb 2-1: configuration #1 chosen from 1 choice Oct 5 07:29:46 ude kernel: scsi2 : SCSI emulation for USB Mass Storage devices Oct 5 07:29:51 ude kernel: Vendor: WDC WD32 Model: WD-WCAMR1683855 Rev: 5J08 Oct 5 07:29:51 ude kernel: Type: Direct-Access ANSI SCSI revision: 02 Oct 5 07:29:51 ude kernel: SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB) Oct 5 07:29:51 ude kernel: sdb: Write Protect is off Oct 5 07:29:51 ude kernel: SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB) Oct 5 07:29:51 ude kernel: sdb: Write Protect is off Oct 5 07:29:51 ude kernel: sdb: sdb1 sdb2 sdb4 < sdb5 sdb6 > Oct 5 07:29:51 ude kernel: sd 2:0:0:0: Attached scsi disk sdb Oct 5 07:29:51 ude kernel: sd 2:0:0:0: Attached scsi generic sg1 type 0 ude:~#時計狂いっ放し。
ude:~# fdisk /dev/sdb The number of cylinders for this disk is set to 38913. There is nothing wrong with that, but this is larger than 1024, and could in certain setups cause problems with: 1) software that runs at boot time (e.g., old versions of LILO) 2) booting and partitioning software from other OSs (e.g., DOS FDISK, OS/2 FDISK) Command (m for help): p Disk /dev/sdb: 320.0 GB, 320072933376 bytes 255 heads, 63 sectors/track, 38913 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sdb1 1 125 1004031 83 Linux /dev/sdb2 126 748 5004247+ 83 Linux /dev/sdb4 749 38913 306560362+ 5 Extended /dev/sdb5 749 873 1004031 83 Linux /dev/sdb6 874 38913 305556268+ 83 Linux Command (m for help):なんで、sdb5 が Linux なん？
Command (m for help): t Partition number (1-6): 5 Hex code (type L to list codes): 82 Changed system type of partition 5 to 82 (Linux swap / Solaris) Command (m for help): p Disk /dev/sdb: 320.0 GB, 320072933376 bytes 255 heads, 63 sectors/track, 38913 cylinders Units = cylinders of 16065 * 512 = 8225280 bytes Device Boot Start End Blocks Id System /dev/sdb1 1 125 1004031 83 Linux /dev/sdb2 126 748 5004247+ 83 Linux /dev/sdb4 749 38913 306560362+ 5 Extended /dev/sdb5 749 873 1004031 82 Linux swap / Solaris /dev/sdb6 874 38913 305556268+ 83 Linux Command (m for help): w The partition table has been altered! Calling ioctl() to re-read partition table. Syncing disks. ude:~#
ude:~# mkfs.ext3 -j /dev/sdb1
mke2fs 1.40-WIP (14-Nov-2006)
Filesystem label=
OS type: Linux
Block size=4096 (log=2)
Fragment size=4096 (log=2)
125696 inodes, 251007 blocks
12550 blocks (5.00%) reserved for the super user
First data block=0
Maximum filesystem blocks=260046848
8 block groups
32768 blocks per group, 32768 fragments per group
15712 inodes per group
Superblock backups stored on blocks:
32768, 98304, 163840, 229376
Writing inode tables: done
Creating journal (4096 blocks): done
Writing superblocks and filesystem accounting information: done
This filesystem will be automatically checked every 25 mounts or
180 days, whichever comes first. Use tune2fs -c or -i to override.
ude:~# mkfs.ext3 -j /dev/sdb2
mke2fs 1.40-WIP (14-Nov-2006)
Filesystem label=
OS type: Linux
Block size=4096 (log=2)
Fragment size=4096 (log=2)
626496 inodes, 1251061 blocks
62553 blocks (5.00%) reserved for the super user
First data block=0
Maximum filesystem blocks=1283457024
39 block groups
32768 blocks per group, 32768 fragments per group
16064 inodes per group
Superblock backups stored on blocks:
32768, 98304, 163840, 229376, 294912, 819200, 884736
Writing inode tables: done
Creating journal (32768 blocks): done
Writing superblocks and filesystem accounting information: done
This filesystem will be automatically checked every 28 mounts or
180 days, whichever comes first. Use tune2fs -c or -i to override.
ude:~# mkfs.ext3 -j /dev/sdb6
mke2fs 1.40-WIP (14-Nov-2006)
Filesystem label=
OS type: Linux
Block size=4096 (log=2)
Fragment size=4096 (log=2)
38207488 inodes, 76389067 blocks
3819453 blocks (5.00%) reserved for the super user
First data block=0
Maximum filesystem blocks=0
2332 block groups
32768 blocks per group, 32768 fragments per group
16384 inodes per group
Superblock backups stored on blocks:
32768, 98304, 163840, 229376, 294912, 819200, 884736, 1605632, 2654208,
4096000, 7962624, 11239424, 20480000, 23887872, 71663616
Writing inode tables: done
Creating journal (32768 blocks): done
Writing superblocks and filesystem accounting information: done
This filesystem will be automatically checked every 28 mounts or
180 days, whichever comes first. Use tune2fs -c or -i to override.
ude:~# mkfs.xfs -f /dev/sdb2
meta-data=/dev/sdb2 isize=256 agcount=8, agsize=156382 blks
= sectsz=512 attr=0
data = bsize=4096 blocks=1251056, imaxpct=25
= sunit=0 swidth=0 blks, unwritten=1
naming =version 2 bsize=4096
log =internal log bsize=4096 blocks=2560, version=1
= sectsz=512 sunit=0 blks
realtime =none extsz=65536 blocks=0, rtextents=0
ude:~# mkfs.xfs -f /dev/sdb6
meta-data=/dev/sdb6 isize=256 agcount=16, agsize=4774316 blks
= sectsz=512 attr=0
data = bsize=4096 blocks=76389056, imaxpct=25
= sunit=0 swidth=0 blks, unwritten=1
naming =version 2 bsize=4096
log =internal log bsize=4096 blocks=32768, version=1
= sectsz=512 sunit=0 blks
realtime =none extsz=65536 blocks=0, rtextents=0
ude:~#
でかい HDD はフォーマットにまで時間がかかって無駄。sdb5 は swap に。
ude:~# mkswap /dev/sdb5 Setting up swapspace version 1, size = 1028120 kB no label, UUID=6b5ad802-dff5-46cd-9fe5-6b65c9f66d59 ude:~#
:
:
Marvell Serial ATA Adapter
Integrated Sata device found
Device 0: OK
Model: WDC WD3200SD-01KNB0 Firm: 08.05J08 Ser#: WD-WCAMR1683855
Type: Hard Disk
Supports 48-bit addressing
Capacity: 305245.3 MB = 298.0 GB (625142448 x 512)
Device 1: OK
Model: Maxtor 6Y160M0 Firm: YAR511W0 Ser#: Y48DJ6QE
Type: Hard Disk
Supports 48-bit addressing
Capacity: 156334.5 MB = 152.6 GB (320173056 x 512)
Using device ide0, partition 1
Loading from block device ide device 0, partition 1: Name: hda1
Type: U-Boot File:/uImage.buffalo
0 bytes read
Image Name:
Created: 1971-01-24 8:57:36 UTC
Image Type: Invalid CPU Unknown OS Multi-File Image (uncompressed)
Data Size: 50332672 Bytes = 48 MB
Load Address: 04000400
Entry Point: 05000400
Contents:
Image 0: 268436480 Bytes = 256 MB
Image 1: 285213696 Bytes = 272 MB
Image 2: 301990912 Bytes = 288 MB
Image 3: 318768128 Bytes = 304 MB
Image 4: 335545344 Bytes = 320 MB
Image 5: 352322560 Bytes = 336 MB
Image 6: 369099776 Bytes = 352 MB
Image 7: 385876992 Bytes = 368 MB
Image 8: 402654208 Bytes = 384 MB
Image 9: 419431424 Bytes = 400 MB
Image 10: 436208640 Bytes = 416 MB
Image 11: 452985856 Bytes = 432 MB
Image 12: 469763072 Bytes = 448 MB
Image 13: 486540288 Bytes = 464 MB
Image 14: 503317504 Bytes = 480 MB
Image 15: 520094720 Bytes = 496 MB
Image 16: 536871936 Bytes = 512 MB
Image 17: 553649152 Bytes = 528 MB
Image 18: 570426368 Bytes = 544 MB
Image 19: 587203584 Bytes = 560 MB
Image 20: 603980800 Bytes = 576 MB
Image 21: 620758016 Bytes = 592 MB
Image 22: 637535232 Bytes = 608 MB
Image 23: 654312448 Bytes = 624 MB
Image 24: 671089664 Bytes = 640 MB
Image 25: 687866880 Bytes = 656 MB
Image 26: 704644096 Bytes = 672 MB
Image 27: 721421312 Bytes = 688 MB
Image 28: 738198528 Bytes = 704 MB
Image 29: 754975744 Bytes = 720 MB
Image 30: 771752960 Bytes = 736 MB
Image 31: 788530176 Bytes = 752 MB
Image 32: 805307392 Bytes = 768 MB
Image 33: 822084608 Bytes = 784 MB
Image 34: 838861824 Bytes = 800 MB
Image 35: 855639040 Bytes = 816 MB
:
:
たちあがってこなひ。。。。
sda1 があっては駄目なのか？？？？
|
|
← debian 化（２１）死んだ ST3250823AS |
ハックの記録 LinkStation／玄箱 をハックしよう |
→ debian 化（２３）セルフで sda の作り直し |
