: : Marvell Serial ATA Adapter Integrated Sata device found Device 0: OK Model: WDC WD3200SD-01KNB0 Firm: 08.05J08 Ser#: WD-WCAMR1683855 Type: Hard Disk Supports 48-bit addressing Capacity: 305245.3 MB = 298.0 GB (625142448 x 512) Using device ide0, partition 1 Loading from block device ide device 0, partition 1: Name: hda1 Type: U-Boot File:/uImage.buffalo 1757556 bytes read Image Name: Linux-2.6.16.16-arm1 Created: 2008-07-22 7:22:37 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1757492 Bytes = 1.7 MB Load Address: 00008000 Entry Point: 00008000 Using device ide0, partition 1 Loading from block device ide device 0, partition 1: Name: hda1 Type: U-Boot File:/initrd.buffalo 5622690 bytes read Image Name: initrd Created: 2008-07-22 7:23:07 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 5622626 Bytes = 5.4 MB Load Address: 00000000 Entry Point: 00000000 Using device ide1, partition 1 ** Bad partition 1 ** serch_boot_drv (182)>No kernel_file 1 Using device ide1, partition 1 ** Bad partition 1 ** serch_boot_drv (237)>No init_file 1 Booting from Device 0 hit any key to switch tftp boot. Hit any key to stop autoboot: 0 Hit any key to stop autoboot: 0 Using device ide0, partition 1 Loading from block device ide device 0, partition 1: Name: hda1 Type: U-Boot File:/uImage.buffalo 1757556 bytes read Using device ide1, partition 1 ** Bad partition 1 ** ## Booting image at 00100000 ... Image Name: Linux-2.6.16.16-arm1 Created: 2008-07-22 7:22:37 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1757492 Bytes = 1.7 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at 00800000 ... Image Name: initrd Created: 2008-07-22 7:23:07 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 5622626 Bytes = 5.4 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Starting kernel ... arg:console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 func=0 BOOTVER=1.13 CONFIG_BUFFALO_PLATFORM CONFIG_BUFFALO_LINKSTATION_LSWSGL_R1 --- : : Intergrated Sata device found scsi0 : Marvell SCSI to SATA adapter scsi1 : Marvell SCSI to SATA adapter ** BUFFALO Disable Command Queuing Function [0 0] ** Vendor: WDC Model: WD3200SD-01KNB0 Rev: 08.0 Type: Direct-Access ANSI SCSI revision: 03 Linux IAL (ERROR) : retry command host=0, bus=0 SCpnt = c1449ba0 SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB) sda: Write Protect is off SCSI device sda: drive cache: write back SCSI device sda: 625142448 512-byte hdwr sectors (320073 MB) sda: Write Protect is off SCSI device sda: drive cache: write back sda: sda1 sda2 sda4 < sda5 sda6 > sd 0:0:0:0: Attached scsi disk sda sd 0:0:0:0: Attached scsi generic sg0 type 0 : : BUFFALO INC. LinkStation series LS-WSGL678 login:ディスクを1台しかつないでないので、ERROR LED が 16 を示している。
BUFFALO INC. LinkStation series LS-WSGL678 login: root root@LS-WSGL678:~# mdadm -D /dev/md0 /dev/md0: Version : 00.90.03 Creation Time : Thu Jun 19 16:33:50 2008 Raid Level : raid1 Array Size : 1003904 (980.54 MiB 1028.00 MB) Device Size : 1003904 (980.54 MiB 1028.00 MB) Raid Devices : 2 Total Devices : 1 Preferred Minor : 0 Persistence : Superblock is persistent Update Time : Thu Nov 1 00:00:20 2007 State : clean, degraded Active Devices : 1 Working Devices : 1 Failed Devices : 0 Spare Devices : 0 UUID : adbe578f:b86ab25a:09937ff0:e2de4343 Events : 0.1325 Number Major Minor RaidDevice State 0 8 1 0 active sync /dev/sda1 1 0 0 1 removed root@LS-WSGL678:~# mdadm -D /dev/md1 /dev/md1: Version : 00.90.03 Creation Time : Thu Jun 19 16:33:51 2008 Raid Level : raid1 Array Size : 5004160 (4.77 GiB 5.12 GB) Device Size : 5004160 (4.77 GiB 5.12 GB) Raid Devices : 2 Total Devices : 1 Preferred Minor : 1 Persistence : Superblock is persistent Update Time : Thu Nov 1 00:05:01 2007 State : clean, degraded Active Devices : 1 Working Devices : 1 Failed Devices : 0 Spare Devices : 0 UUID : db218435:100e25e7:d2ba170f:d67ec206 Events : 0.16787 Number Major Minor RaidDevice State 0 8 2 0 active sync /dev/sda2 1 0 0 1 removed root@LS-WSGL678:~# mdadm -D /dev/md2 mdadm: md device /dev/md2 does not appear to be active. root@LS-WSGL678:~# mdadm -D /dev/md10 /dev/md10: Version : 00.90.03 Creation Time : Thu Jun 19 16:33:54 2008 Raid Level : raid1 Array Size : 1003904 (980.54 MiB 1028.00 MB) Device Size : 1003904 (980.54 MiB 1028.00 MB) Raid Devices : 2 Total Devices : 1 Preferred Minor : 10 Persistence : Superblock is persistent Update Time : Thu Nov 1 00:40:52 2007 State : clean, degraded Active Devices : 1 Working Devices : 1 Failed Devices : 0 Spare Devices : 0 UUID : ba25aab6:f1bb3eab:c75c26a7:a754b72a Events : 0.19 Number Major Minor RaidDevice State 0 8 5 0 active sync /dev/sda5 1 0 0 1 removed root@LS-WSGL678:~#
買うにしても、2.5 インチ HDD は高いしなぁ。。。
|
← アレイの削除 |
ハックの記録 LinkStation/玄箱 をハックしよう |
→ 3.5 インチ HDD をドライブできない電源 |